Vehicle Sound Deadener Butyl Rubber Aluminium Foil Green Sound
sound deadener products based on butyl rubber, and covered with
aluminum sheet on the face. It has good performance on adhesion,
weather resistance, aging resistance and waterproof. So it is one
of the best environmentally friendly products that could be used in
various commercial vehicles for shock absorption, reinforcement,
noise reduction and sound insulation.
1. Appearance of black sheet, aluminum foil backing.
2. Density 1.77 g/cm3, mainly based on customer's requirement.
3. Heat resistance: 90 degrees Celsius for 2 hours, with no
flowing, cracking and deformation.
4. Low temperature flexibility: below 40 degrees Celsius, there is
Suitable for auto body, auto air conditioning, sheet metal cabinet
riveted with the car floor on sealing, shock absorbing, heat
insulating and noise eliminating.
Q. How does it work?
A. Sound from outside the vehicle cabin is easily tranferred
through the sheet metal paneling. our Sound Deadening Pads is
adhered to this sheet metal, causing a "deadening" effect by adding
mass to the panel. A simple example would be to imagine banging on
an empty metal tin, compared to one that was lined with dried paint
Q. Where do you put?
A. can be used in many parts of a car, the most common being under
the floor carpet on the floor pan, the interior of the boot, and on
the inside of the outer door skins.
Q. How much difference will it make?
A. This will vary based on a lot of different factors, including
how loud the vehicle already is inside, and how much sound
deadening is already fitted from the factory. Older, lower spec
models and vans usually show the best improvement.
Q. What tools do I need?
A. To install itself to a flat surface, none. The Sound Deadening
Pads comes with a peel and stick pressure sensitive adhesive
backing for easy install. For complex installations, a heat gun
will help with difficult curves, and either heavy scissors, or a
stanley knife if cutting is required. Removal of trim components
etc in the vehicle would obviously require the necessary hand
Q. How much do I need?
A. To cover the floor pan of a standard size car, you would need at
least the the standard size approx 3.25sq metres. More thorough
installations would need material for the firewall up behind the
dash, the door skins, and boot for example. Please contact us if
you need to purchase a large quantity.
|1. Life Time||Over 10 years|
|3. MOQ||1000 Sheets|
|4. Surface Color||Green|
|5. MaterButyl||Aluminum Foil Butyl Rubber|
|6. Butyl rubber Thickness||1.9mm|
|7. Aluminium Foil Thickness||0.1mm|